Fujitsu Eternus DX100 S3 User Manual page 828

Appendix A Error Messages/Error Codes
A.1 Error Messages
Message
number
E0010
E0011
E0012
E0014
E0015
E0019
E0020
E0021
E0030
E0031
E0032
E0033
E0034
E0035
E0041
E0042
Inconsistent model type of device.
The specified operation is not appropriate for the type of device. Check the type of device identified in the
details of this message.
Inconsistent network setup.
This message indicates that the network settings are incorrect. Check the network settings by using the
"show network" command.
Inconsistent e-mail setup.
This message indicates that the e-mail settings are incorrect. Check the e-mail settings by using the
"show email-notification" command.
Inconsistent disk status.
Cannot execute the specified command because the disk is not in an appropriate state. Check the status
of the disks identified in the details of this message.
Inconsistent enclosure status.
Cannot execute the specified command because the enclosure is not in an appropriate state. Check the
status of the disks identified in the details of this message.
Inconsistent parameter.
The specified parameter does not correspond with the command. Check the parameters indicated in the
details of this message.
Internal error.
An internal error has occurred. Retry the command, and if unsuccessful, contact the support department.
The requested operation has failed.
The specified command process has failed. If this error continues to recur even after numerous command
retries, the specified command cannot be executed for an unknown reason.
Command not supported.
This command is not supported. Check the execution conditions (Example: model type, host interface
type (FC/SAS/iSCSI), and firmware levels).
Reserved keyword is used.
Reserved keyword cannot be used. Use another name.
Controller firmware cannot be downgraded.
Reverting to an earlier version is not allowed for the hot application mode. Confirm the controller
firmware version by using the "show firmware" command, and use the cold application mode if necessary.
Not applicable to this target.
The specified resource cannot be applied to the specified command process. Check the specified resource.
Mainframe resources.
The specified Mainframe resource cannot be applied to the specified command process. Check the
specified resource.
Disk firmware can only be upgraded.
Confirm the firmware version that is registered in the ETERNUS DX and the firmware version that has been
applied to the disks. The disk firmware that is currently being used can only be upgraded to a newer
version.
Incorrect password syntax.
The syntax of the specified password is incorrect. Check that the length and characters of the passwords
are acceptable.
Incorrect password.
The password entered is incorrect. Check and then re-enter the password.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
Message
Countermeasure for the error
828
P2X0-1210-05ENZ0