Fujitsu Eternus DX100 S3 User Manual page 848

Appendix A Error Messages/Error Codes
A.1 Error Messages
Message
number
E5504
E5601
E5701
E5900
E6000
E6001
E6002
E6003
E6004
E6005
E6006
E6007
E6008
E6009
E6010
E6011
E6012
E6201
E7001
E7002
The specified Additional IP Information setting is invalid.
The specified virtual port setting is invalid.
The automatic setup of IPv6 address cannot be performed.
The setup of automatic IPv6 address typing cannot be performed.
The factory setup is not done.
The factory settings have not been performed.
Command error.
Common MMI error.
Advanced Copy session that covers the entire volume is active.
An Advanced Copy session that affects the entire volume is being performed.
The specified volume is ODX Buffer Volume.
The specified volume is an ODX Buffer volume.
The specified volume is volume during Zero Reclamation execution.
The specified volume is a volume that is currently undergoing Zero Reclamation.
Offloaded Data Transfer Mode is valid.
The Offloaded Data Transfer mode is enabled.
Offloaded Data Transfer Mode is not valid.
The Offloaded Data Transfer mode is disabled.
ODX Buffer Volume exist.
ODX Buffer volumes exist.
The specified volume is not ODX Buffer Volume.
The specified volume is not an ODX Buffer volume.
Offloaded Data Transfer in process.
An Offloaded Data Transfer is in progress.
The specified volume is not volume during Zero Reclamation execution.
The specified volume is a volume that is currently not undergoing Zero Reclamation.
Not available under operating Bind-in-Cache.
The specified command cannot be executed because Bind-in-Cache is set.
Current cache page size is over specified cache limit size.
The cache capacity that is being used by the Write process has exceeded the specified cache capacity
limit.
Not available under cache limit settings.
The cache memory cannot be used because its capacity is set to be limited.
The RAID migration from which a security level differs requires security authority.
The Security Setting policy is required to perform RAID Migration with a different security level.
The specified RAID Group does not consist of SED.
The specified RAID group does not consist of SEDs.
SED authentication key is not registered.
The SED authentication key is not registered.
The master server is not registered in the key management group.
The master server is not registered in the key management group.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
Message
Countermeasure for the error
848
P2X0-1210-05ENZ0