Create Lun-Group - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > create lun-group

create lun-group

This command creates a LUN group. The maximum number of available groups depends on the number of
available host interface ports and the model type. Usually a LUN can be assigned a value from 0 – 255. Note
that this does not apply in the following environments:
• HP-UX host environment
From 0 – 1023 can be assigned. The resource combines two LUN groups.
• BS2000 environment
From 0 – 4095 can be assigned. The resource combines eight LUN groups.
■ Syntax
create lun-group -name
{-volume-number
■ Parameter
-name
-volume-number
or
-volume-name
-lun
name
volume_numbers
| -volume-name
This parameter specifies a name of the LUN group. Only one LUN group name can be specified
at the same time. For details, refer to
name
LUN group name
This parameter specifies the volume identifiers to associate volumes with host LUNs. One or
more parameters can be specified at the same time. For details, refer to
Syntax" (page 26). If two or more LUNs are specified, these parameters must be specified in
the same order.
Example:
-volume-number 10-12 -lun 1-3
-> The volume #10 and LUN 1 are pairs.
-> The volume #11 and LUN 2 are pairs.
-> The volume #12 and LUN 3 are pairs.
-volume-name v1,v2 -lun 1-2
-> The volume named "v1" and LUN 1 are pairs.
-> The volume named "v2" and LUN 2 are pairs.
volume_numbers
Volume number
volume_names
Volume name
This parameter specifies the host LUNs to associate volumes with. Two or more parameters can
be specified by separating them with a comma (,), a hyphen (-), or both. If two or more
volumes are specified, these parameters must be specified in the same order.
Example: -lun 0,1 -lun 0-10 -lun 0,1-10
luns
Host LUN
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
volume_names
} -lun
"1.2.5 Alias Name Syntax" (page
326
luns
23).
"1.2.10 Volume
P2X0-1210-05ENZ0