Import Ssl-Certificate - Fujitsu Eternus DX100 S3 User Manual

Chapter 5 System Settings and Display
5.2 Network Management > import ssl-certificate

import ssl-certificate

This command imports and registers the SSL server certificate that is signed by the certificate provider.
■
Syntax
import ssl-certificate -port {maintenance | remote| fst} -server
login_user_account
-user
[-key-filename
■ Parameter
-port
-server
-user
-cert-filename
-key-filename
[-cert-filename
key-filename ] [-indicator {enable | disable}]
This parameter specifies which Ethernet port is used to connect to the FTP server.
For further information, refer to
maintenance
MNT port
remote RMT port
fst FST port (not supported in the ETERNUS DX100 S3/DX200 S3 or the ETERNUS
DX200F)
This parameter specifies the name of the FTP server on which the certificate and key file are
stored. The server name should be in IPv4 standard notation (a base 256 "d.d.d.d" string)
format, IPv6 address format or a fully qualified domain name (FQDN).
Example: -server 192.168.1.20
Example: -server fd80::abd0:223:ad
Example: -server foo.bar
server_name
FTP server name
This parameter specifies a user account name for access to the FTP server. This command
displays an FTP server password prompt.
login_user_account
User account name
Optional. This parameter specifies the filename to load the certificate file. If omitted,
"server.crt" (default file) is used. If the same file already exists, it is overwritten.
cert-filename
Filename to load the certificate file
Optional. This parameter specifies the filename to load the certificate and the key file. If
omitted, "server.key" (default file) is used. If the same file already exists, it is overwritten.
key-filename
Filename to load the certificate and the key file
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
server_name
cert-filename
]
"1.11 Note for Specifying FTP Server" (page
582
35).
P2X0-1210-05ENZ0