Fujitsu Eternus DX100 S3 User Manual page 843

Appendix A Error Messages/Error Codes
A.1 Error Messages
Message
number
E5323
E5324
E5325
E5326
E5327
E5328
E5329
E5330
E5331
E5332
E5333
E5334
E5335
E5336
E5337
E5338
The specified operation is not a "Force specify".
The session cannot be transitioned to Suspend status or cannot be deleted because it is not forcibly
specified.
A STOP command is issued to a session that is not the oldest for a SnapOPC+ operation without specifying
the session forcibly.
There is no path to access to the copy source volume or copy destination volume.
The RAID group for the copy source LU or the copy destination LU is blocked.
The specified volume is an Advanced Copy read-only volume. It cannot be set as copy destination volume.
The copy destination LU is write-protected.
The STOP command was issued to a SnapOPC/SnapOPC+ session which is in progress of restoring.
A STOP command is issued to a SnapOPC session that is being restored.
REC buffer transfer is not complete in time or buffer recovery is processing under SUSPEND command pro-
cess. SUSPEND command cannot be done.
The REC buffer transfer did not complete within a certain period of time.
A buffer recovery is performed while the SUSPEND command is being processed (the SUSPEND command
cannot be executed because untransferred data is recovered).
REC buffer data transfer is under monitoring. The specified session cannot be reversed.
The session cannot be reversed because the untransferred REC buffer is being monitored.
It will lead to EC/REC cascade copy session that is not in "Suspend" state but has cascade source volume.
The session cannot be reversed because it is the cascade source for an EC/REC that is not in Suspend
status.
The copy session has already been reversed.
The session cannot be reversed because it has been already reversed.
The number of copy sessions exceeds the allowable maximum copy sessions for this storage.
The number of sessions exceeds the maximum number in a single ETERNUS DX.
The copy license is not valid.
The copy license is invalid.
The number of copy sessions exceeds the allowable maximum copy sessions for each copy source volume.
The number of sessions exceeds the maximum number for a copy source LU in a single ETERNUS DX.
The number of copy sessions exceeds the allowable maximum copy sessions for each copy destination
volume.
The number of sessions exceeds the maximum number for a copy destination LU in a single ETERNUS DX.
The number of SnapOPC+ copy session generations exceeds the maximum for a copy source volume.
The number of SnapOPC+ generations exceeds the maximum number for a copy source LU.
Copy area of copy source volumes in monitoring copy sessions is overlap.
The copy source LU areas of some monitoring sessions overlap.
The new copy session settings are the same with an existing one's. The new copy session cannot be
started.
The scope of the new copy session and the existing copy session are identical (excluding the case when
these sessions are OPC sessions or QuickOPC sessions and these session restart in Copying status) or the
copy destination areas of the new copy session and the existing copy overlap each other.
Copy destination volume and cascade copy destination volume in the copy session is overlap.
The copy destination for the relevant session overlaps the cascade linkage destination.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
Message
Countermeasure for the error
843
P2X0-1210-05ENZ0