Chapter 4 Copy Function Settings and Display
4.1 Advanced Copy Management
■
SDP (Snap Data Pool) creation
Create SDPVs in the created RAID group.
[Example]
Creating one SDPV having 1 [TB] capacity in the RAID group#4
CLI> create volume -name SDPV01 -rg-number 4 -type sdpv -size 1tb -count 1
Volume Format is performed automatically after the SDPV is created.
4.1.2.3
Operation settings
■
Operation policy setup
Set the threshold for notification of SDPV overflow that may occur during copy operations and the action of the
notification.
[Example]
Setting for notification of "information", "warning", and "error" if up to 60% and 80%, and more than 95% of
the SDPV capacity is used respectively.
CLI> set advanced-copy-policy -level information -threshold 60
CLI> set advanced-copy-policy -level warning -threshold 80
CLI> set advanced-copy-policy -level error -threshold 95
[Example]
Set whether to send a notification for each threshold with an e-mail message (or SNMP) or not.
CLI> set event-notification -level i-sdp-policy-information -target email -suppression disable
4.1.3
Copy Session Management
4.1.3.1
Copy management
After preparation for Advanced Copy is complete, create a copy session to start copying volumes. During
operation, also check the status of the copy sessions and delete unnecessary copy sessions.
■
SnapOPC+ copy execution
Create a copy session by using the "start advanced-copy" command to start the SnapOPC+ copy.
[Example]
Starting the SnapOPC+ copy from the copy source volume#0 to the copy destination volume (SDV) #100.
CLI> start advanced-copy -source-volume-number 0 -destination-volume-number 100
397
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
P2X0-1210-05ENZ0