Show Nas-Multipath - Fujitsu Eternus DX100 S3 User Manual

Chapter 7 NAS Function Setting and Display
7.4 Network Interface Multipath Configuration > show nas-multipath

show nas-multipath

This command displays the NAS port multipath configuration.
■
Syntax
show nas-multipath
■ Parameter
No parameters.
■ Output
CM#x CA#y Port#z <-> CM#x CA#y Port#z
■ Example(s)
The following example shows the setting to display the ports for which a multipath configuration is used:
CLI> show nas-bonding
<Bonding Information>
Master Port
Member Port
Bonding Mode
Hash Policy
<Bonding Information>
Master Port
Member Port
Bonding Mode
Hash Policy
Port numbers for which a multipath is configured
[CM#0 CA#0 Port#0]
[CM#0 CA#1 Port#0, CM#0 CA#1 Port#1]
[balance-xor]
[L2]
[CM#1 CA#0 Port#0]
[CM#1 CA#1 Port#0, CM#1 CA#1 Port#1]
[balance-xor]
[L2]
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
767
P2X0-1210-05ENZ0