Fujitsu Eternus DX100 S3 User Manual page 858

Appendix A Error Messages/Error Codes
A.1 Error Messages
Message
number
EB902
EB903
EB904
EB906
EBE00
EBE01
EBE02
EBE03
EBE04
EBE05
EBE06
EBE07
EBE08
EBE09
EBE20
EBE21
REC Buffer is mirror recovery status.
The REC buffer is in mirror recovery status.
CFL is canceled because REC session is not continuable state.
CFL is suspended because of the REC session status.
Concurrent Firmware Loading is canceled because the remote copy session is in a status that does not
allow a remote copy session to continue.
Take one of the following actions:
•
Recover the Advanced Copy path.
•
Set the concurrent loading (path switching linkage) mode to "Manual (Operator linkage)" and try
again.
•
Suspend the REC sessions that is not in "Suspend" status, "Error Suspend" status, or "Halt" status by
using the software that started this REC session.
REC path is set in this device.
A REC path has been configured.
There are CA port that port mode is CA/RA or RA is exists.
An RA mode port or an RA/CA mode port exists.
The specified volume is being used as a NAS volume.
The specified volume is being used as a NAS volume.
This operation cannot be performed to the NAS resources.
This operation cannot be performed to the NAS resources.
The NAS function is not available.
The NAS function is not available.
The number of NAS-TPVs exceeds the maximum number of registrations.
The number of NAS-TPVs exceeds the maximum number of registrations.
The number of NAS-TPVs (Backup) exceeds the maximum number of registrations.
The number of NAS-TPVs (Backup) exceeds the maximum number of registrations.
Number of NAS System Volume has reached the system limit.
The number of registered SYSVOLs or SYSVOLs that are to be created has reached the maximum number
of registrations.
Capacity of NAS System Volume has reached the system limit.
The logical capacity of registered SYSVOLs or SYSVOLs that are to be created has reached the maximum
capacity of registrations.
An error was detected in NAS Engine.
An error was detected in the NAS Engine.
NAS system volume does not exist.
The NAS system volume is not registered.
NAS system volume is not writable.
The NAS system volume is not writable.
Specified NAS share does not exist.
The specified NAS share folder does not exist.
The number of NAS share exceeds the maximum number of registrations.
The number of NAS share folders exceeds the maximum number of registrations.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
Message
Countermeasure for the error
858
P2X0-1210-05ENZ0