Appendix D Basic Setting Examples
D.2 Settings for Various Host Accesses
5
Map a volume with LUNs and create a LUN group named LUN001.
CLI> create lun-group -name LUN001 -volume-name v0,v1 -lun 0-1
In this example, volumes are mapped as follows:
•
Volume v0 is paired with LUN 0.
•
Volume v1 is paired with LUN 1.
6
Set the relationship between port group PG0001, LUN group LUN001, and host group HG01.
CLI> set host-affinity -port-group-name PG0001 -lg-name LUN001 -host-group-name HG01
D.2
Settings for Various Host Accesses
This section describes host access settings that are not covered in
924).
An outline of these settings is provided below.
•
Specifying a host and performing mapping (host affinity mode)
Mapping (Host Affinity Mode)" (page
(1) Enable the host affinity mode of the host interface port.
(2) Set the parameter that controls the host interface port.
(3) Register a host that is used to identify the HBAs (Host Bus Adapter).
(4) Create a LUN group.
(5) Set the relationship between the host, host interface ports, and LUN group.
•
Specifying a port group and performing LUN mapping
Mapping" (page
(1) Set the parameter that controls the host interface port.
(2) Set a host response.
(3) Create a port group.
(4) Create a LUN group.
(5) Set the relationship between the port group, LUN group, and host response.
926))
927))
925
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
"D.1.2 Host Access Setting Procedure" (page
("D.2.1 Specifying a Host and Performing
("D.2.2 Specifying a Port Group and Performing LUN
End of procedure
P2X0-1210-05ENZ0