Fujitsu Eternus DX100 S3 User Manual page 493

Chapter 5 System Settings and Display
5.2 Network Management > show network
Allowable IP Address List
Wake on LAN
Ipv6
Master Link Local IP Address
Master Connect IP Address
Slave Link Local IP Address
Slave Connect IP Address
Length of Subnet Prefix
MAC Address
■ Example(s)
The following example displays the network (LAN) configuration parameters:
CLI> show network
MNT Port
<IPv4 Information>
Ipv4
Master IP Address
Slave IP Address
Subnet Mask
Gateway
Primary DNS
Secondary DNS
Speed and Duplex
Wake on LAN
List of allowed IP addresses
NO. Allowable IP address number
IP Address Allowable IP address (IPv4)
Subnet Mask
Subnet mask (IPv4)
Connect IP Address
Connect IP Address and mask length (IPv6)
Indicates whether the Wake on LAN function is enabled on the maintenance port.
Indicates whether IPv6 settings are enabled or disabled (Enable/Disable/Factory Default)
(When the factory default network setting is set, this information is displayed as "Factory
Default" for the MNT port.)
Link local IP address (Master) (IPv6)
Connect IP address (Master) (IPv6)
Link local IP address (Slave) (IPv6)
Connect IP address (Slave) (IPv6)
Prefix length (IPv6)
Each MAC address of the port on both controller modules
A hyphen (-) is displayed in the field of CM#1 for an ETERNUS DX with a single controller.
[Enable]
[192.168.1.1]
[192.168.1.2]
[255.255.255.0]
[192.168.1.250]
[192.168.1.253]
[192.168.1.254]
[Auto Negotiation]
[Disable]
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
493
P2X0-1210-05ENZ0