Fujitsu Eternus DX100 S3 User Manual page 303

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set mapping
-lun
■ Example(s)
The following example sets the relationship between host interface port #0 on CM#0 CA#1, the volume
named "VOL001", and LUN #1:
CLI> set mapping
The following example sets the relationship between host interface port #0 and #1 on CM#0 CA#0, the
volume named "VOL002", and LUN #2:
CLI> set mapping
(identical with the following)
CLI> set mapping -port 000 -volume-name VOL002 -lun 2
CLI> set mapping -port 001 -volume-name VOL002 -lun 2
The following example sets the relationship between host interface port #0 on CM#0 CA#0, volumes #0 – #9,
and LUNs #0 – #9:
CLI> set mapping
This parameter specifies the LUNs to be associated. If two or more volumes are specified, these
parameters must be specified in the same order.
Two or more parameters can be specified by separating them with a comma (,), a hyphen (-),
or both.
Example: -lun 1,2 -lun 0-10 -lun 1,2-9
luns
LUN
-port 010 -volume-name VOL001 -lun 1
-port 000,001 -volume-name VOL002 -lun 2
-port 000 -volume-number 0-9 -lun 0-9
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
303
P2X0-1210-05ENZ0