Chapter 1 Overview; Accessing Cli - Fujitsu Eternus DX100 S3 User Manual

Chapter 1
Overview
The ETERNUS DX command line interface (hereinafter referred to as "CLI") is installed in controllers of the
ETERNUS DX. The CLI is used for performing settings and maintenance via commands and command scripts.
This chapter describes the outlines for the CLI.
There are no drive enclosures in the ETERNUS DX200F. In addition, the controller enclosure only has SSDs
installed. Therefore, functions that are related to drive enclosures, SAS disks, SAS Self Encrypting Drives, or
Nearline SAS disks cannot be used.
1.1

Accessing CLI

The CLI software embedded in each ETERNUS DX controller module enables storage systems to be configured,
monitored, and managed. This may be done via LAN connection to the controller module's Ethernet port,
using telnet, an SSH application, or a terminal emulator on a remote administrator client. For telnet
connection, a user name and password are required. For SSH, in addition to a user name and password, SSH
public key authentication is also supported. For details, refer to the "import ssh-publickey" command.
Default IP address, user name, and password are as follows:
IP address:
user name:
password:
The default IP address is assigned to the following ports.
• With the ETERNUS DX100 S3/DX200 S3 or the ETERNUS DX200F
RMT port
• With the ETERNUS DX500 S3/DX600 S3
FST port
The network for the MNT port must be configured from the "set network" command.
CLI will display the following pre-login message on the terminal:
ETERNUS login is required. [2010-01-01 05:38:00]
The date and time are the local values. However, this message may not be displayed when logged in with
SSH. This is due to the fact it depends on terminal software.
192.168.1.1
root
root
21
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED P2X0-1210-05ENZ0