Fujitsu Eternus DX100 S3 User Manual page 49

Chapter 2 Status Display
2.1 Storage System Status > show fru-ce
CM#n CA#m Port#l Information (n: The controller module number, m: The Channel Adapter number, l:
The port number)
(For FC, iSCSI, FCoE, and SAS)
Port Type
Port Mode
Status/Status Code
Multiple VLAN
Number of IP Addresses
CA Active EC
CA Next EC
Connection Connection condition
Loop ID
Transfer Rate
Link Status Link status (Link Up, Link Down, or if requesting auto negotiation, then the actual
Port WWN
Node WWN
iSCSI Name
iSCSI Alias Name
Indicates whether the host interface port type is FC, iSCSI, FCoE, or SAS.
Indicates whether the host interface port mode is CA, RA, CA/RA auto, or Initiator.
Host interface Port (Port#m) status and the status code
This information only appears when the port type is a 2-port 1G-iSCSI (Hilda) or a 2-port
10G-iSCSI (Hilda).
This information indicates whether multiple VLAN is enabled. When multiple VLAN is
enabled, "Enable" is displayed. When multiple VLAN is disabled, "Disable" is disabled.
When the port mode is RA, "-" is displayed.
This information only appears when the port type is a 2-port 1G-iSCSI (Hilda) or a 2-port
10G-iSCSI (Hilda).
This information indicates the number of IP addresses with enabled ports. When
"Enable" is displayed for the Multiple VLAN item, the number of IP addresses with
enabled ports (from 1 to 16) is displayed. When "Disable" or "-" is displayed for the Mul-
tiple VLAN item, "1" is displayed.
EC number of the active firmware (the current operating firmware)
EC number of the stand-by firmware (the generation number of the firmware after the
next power cycle)
Loop ID
Transfer rate (A value specified by the operator)
transfer rate is displayed.)
Port World-Wide-Name
Node World-Wide-Name
iSCSI Name
iSCSI Alias Name
49
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED P2X0-1210-05ENZ0