Show Nas-Fsck - Fujitsu Eternus DX100 S3 User Manual

Chapter 7 NAS Function Setting and Display
7.10 NAS Function Restoration > show nas-fsck

show nas-fsck

This example shows the result of an integrity check for the file system that is started by executing the "start
nas-fsck" command.
■ Syntax
show nas-fsck
■ Parameter
No parameters.
■
Output
Volume number
Volume name
Message
■ Example(s)
The following example shows the settings when checking NAS TPV #1.
CLI> show nas-fsck
Volume No.
Volume Name
<Message>
/dev/disk/by-id/scsi-3600000e00d2800000028000000030000-part1 (NO WRITE)
/dev/disk/by-id/scsi-3600000e00d2800000028000000030000-part1 is clean
The following example shows the settings when the check result for NAS TPV #2 is displayed.
CLI> show nas-fsck
Volume No.
Volume Name
<Message>
/dev/disk/by-id/scsi-3600000e00d2800000028000000030000-part1 (NO WRITE)
/dev/disk/by-id/scsi-3600000e00d2800000028000000030000-part1 is clean
pdfsck end.
The volume number that is undergoing an integrity check
The name of the volume that is undergoing an integrity check
Progress or check result
[1]
[NAS_TPV]
[2]
[NAS_TPV]
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
816
P2X0-1210-05ENZ0