Flexible Tier Pool Syntax - Fujitsu Eternus DX100 S3 User Manual

Chapter 1 Overview
1.2 The Command Syntax
• Thin Provisioning Pool name
A Thin Provisioning Pool name must be specified when creating a Thin Provisioning Pool. For details about
the syntax, refer to
of Thin Provisioning Pool names. A Thin Provisioning Pool name and a Thin Provisioning Pool number
cannot both be specified in the same command. Do not include spaces before or after commas (,).
• Two or more parameters might not be able to be specified for several commands. For details, refer to the
command descriptions.
• Since Thin Provisioning Pools and Flexible Tier Sub Pools use the same resource, the same number and
name cannot be used for both a Thin Provisioning Pool and a Flexible Tier Sub Pool. If the Thin
Provisioning Pool number or the Thin Provisioning Pool name that is specified for a command is already
used for an FTSP, the command is not executed.
1.2.7

Flexible Tier Pool Syntax

There are two methods for identifying an entered Flexible Tier Sub Pool; Flexible Tier Pool numbers or Flexible
Tier Pool names.
• Flexible Tier Pool number
A Flexible Tier Pool number is automatically created by the system when a Flexible Tier Pool is created.
This is a decimal number. Flexible Tier Pool numbers can be displayed by using the "show flexible-tier-
pools" command.
Flexible Tier Pool numbers can be combined as follows:
- A single Flexible Tier Pool number: 1
- A list of Flexible Tier Pool numbers: 1,8,12
- A hyphenated range of Flexible Tier Pool numbers from
- A list of Flexible Tier Pool numbers, ranges, or both, separated by commas (,): 1,3,10-12
• Flexible Tier Pool name
A Flexible Tier Pool name must be specified when creating a Flexible Tier Pool. For details about the
syntax, refer to
Flexible Tier Pool names. A Flexible Tier Pool name and a Flexible Tier Pool number cannot both be
specified in the same command. Do not include spaces before or after commas (,).
Two or more parameters might not be able to be specified for several commands. For details, refer to the
command descriptions.
"1.2.5 Alias Name Syntax" (page
"1.2.5 Alias Name Syntax" (page
24
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
23). Some commands accept a comma-separated list
a
to z: 2-5
23). Some commands accept a comma-separated list of
P2X0-1210-05ENZ0