Show Sas-Parameters - Fujitsu Eternus DX100 S3 User Manual

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show sas-parameters

show sas-parameters

This command displays the parameters of each SAS host interface port.
■
Syntax
show sas-parameters
■ Parameter
No parameters.
■ Output
Port
Host Affinity
Transfer Rate
Host Response No.
Host Response Name
Reset Scope Range of reset action I_T_L (I: Initiator, T: Target, L:LUN) or T_L (T: Target, L: LUN)
Reserve Cancel at Chip Reset
Each host interface port number
Host affinity mode of each host interface port
SAS transfer rate (Auto Negotiation / 1.5Gbit/s / 3Gbit/s / 6Gbit/s)
Host response number (A hyphen (-) is shown when the host affinity mode is enabled.)
Host response name (A hyphen (-) is shown when the host affinity mode is enabled.)
Indicates whether reservations are canceled or not when a host interface port is reset
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
230
P2X0-1210-05ENZ0