Chapter 7 NAS Function Setting and Display
7.1 Shared Folders > set nas-share
set nas-share
This command changes NAS shared folder settings. If internal resources become insufficient due to a change
in settings, a change error occurs.
When using an authentication server, both CMs must be ready to communicate with the authentication
server. For each CM, the following requirements must be met.
•
Using the "create nas-interface" command, an IP address is assigned to one or more ports.
•
Using the port above, the CM is in a state capable of communicating with the authentication server.
If the above requirements are not met and the command fails, fulfill the requirements, and execute the
command again.
■
Syntax
set nas-share
{-share-number
[-access {r|rw}] [-oplocks {enable|disable}]
[-owner
owner
[-nfs-allow-host {
[-cifs-allow-host {
■
Parameter
-share-number
or
-share-name
or
-all
share_number
| -share-name
] [-group
group
] [-share {active|inactive}]
allow-host
| ""}]
allow-host
| ""}] [-cifs-deny-host {
This parameter specifies a NAS shared folder to be changed. When the "-share-number"
parameter is used, multiple numbers can be specified by inserting a hyphen (-) or a comma (,)
between them as a delimiter. When the "-share-name" parameter is used, only one NAS
shared folder can be specified.
A NAS shared folder that does not exist cannot be specified.
share_number
NAS shared folder number
share_name
NAS shared folder name
-all
All NAS shared folders
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
share_name
| -all}
deny-host
| ""}]
742
P2X0-1210-05ENZ0