Set Nas-Route6 - Fujitsu Eternus DX100 S3 User Manual

Chapter 7 NAS Function Setting and Display
7.5 Network Settings > set nas-route6

set nas-route6

This parameter adds the IPv6 static route of the NAS interface. The specified route remains enabled, unless it
is deleted, even after the system is restarted. If a NAS interface setting is changed or deleted, the route may
be deleted automatically.
The specified route can be checked by using the "show nas-route6 -mode startup" command.
■ Syntax
set nas-route6 -ip
gateway_address
-gw
■
Parameter
-ip
-subnet-prefix-length
-gw
target_ipv6_address
[-subnet-prefix-length
nas-if-number
-nas-if-number
This parameter specifies the destination IPv6 address in the route.
target_ipv6_address
IP address (IPv6 format)
Example: -ip 2001:db8::/32
Specify an IP address on the subnet different from the IP address specified with the "-gw"
parameter.
Optional. This parameter specifies the subnet prefix length between 3 and 128. If this
parameter is omitted, "128" is specified.
prefix_length
Subnet prefix length (3 to 128)
This parameter specifies the gateway IP address that is used by the route.
gateway_address
Gateway IP address (IPv6 format)
Example: -gw fe80::250:56ff:feaa:2c1b
Specify an IP address on the same subnet as the NAS interface.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
prefix_length
786
]
P2X0-1210-05ENZ0