Discover Host-Iscsi-Names - Fujitsu Eternus DX100 S3 User Manual

Fujitsu eternus cli user's guide
Hide thumbs Also See for Eternus DX100 S3:
Table of Contents

Advertisement

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > discover host-iscsi-names

discover host-iscsi-names

This command displays a list of the iSCSI host names that have been discovered for the specified iSCSI port(s).
The iSCSI parameters must be set up first using the "set iscsi-parameters" command.
An iSNS server definition must be set to use this command.
Host Affinity Mode must be enabled to use this command.
Even if an iSNS server is defined, expected IP addresses may not be displayed.
-
If multiple hosts run one of the following host OSes, have an identical iSCSI name, and have different
IP addresses, the IP address of only one of the hosts can be displayed.
•Windows Server 2008 R2
•Windows Server 2008
•Solaris 10
Host information cannot be displayed if the host is running Solaris 11.
Syntax
discover host-iscsi-names [-port {
Parameter
-port
-additional-ip
xyz
|all}] [-additional-ip
Optional. This parameter specifies the iSCSI interface port(s) whose discovered host iSCSI
names are to be listed. One or more host interface ports can be specified at the same time. If
this parameter is omitted, the hosts that are discovered for all the iSCSI interface ports are
displayed.
Example: -port 000,100
For details, refer to
"1.2.15 Host Interface Port Syntax" (page
xyz
"x" is the controller module (CM) number, "y" is the CA number, and "z" is the
iSCSI port number.
Example: "123" indicates CM#1-CA#2-iSCSI Port#3
all
All the iSCSI interface ports (default)
Optional. This parameter specifies the virtual port information number that is set for the target
port. Multiple numbers can be specified by inserting commas between them. This parameter
requires the "-port" parameter to be specified. However, this parameter cannot be specified
when multiple ports or the "all" option cannot be specified for the "-port" parameter.
If this parameter is omitted, "0" (this indicates the actual port) is set for the value of this
parameter.
additional-ip
Virtual port information number (1 – 15)
all
All virtual port information numbers
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
additional-ip
281
]
29).
P2X0-1210-05ENZ0

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents