Fujitsu Eternus DX100 S3 User Manual page 368

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > test iscsi-ping
■ Example(s)
The following example causes two pings to be issued from port#0 on CM#1 CA#0 to the iSCSI host
192.168.2.10. In this case, a "Success" string is displayed. This result indicates that a normal response was
received to both pings.
CLI> test iscsi-ping -port 100 -ip 192.168.2.10 -count 2
Success
The following example uses the same command as the previous example, but in this case, a "Failure" string
is displayed. This result indicates that a normal response was not received for at least one of the pings.
CLI> test iscsi-ping -port 100 -ip 192.168.2.10 -count 2
Failure
The following example sends three pings from port#0 on CM#1 CA#0 to iSCSI host
2001:0db8:0020:0003:1000:0100:0020:0003. In this case, a "Success" string is displayed. This result
indicates that a normal response was received for all of the pings.
CLI> test iscsi-ping -port 100 -ip 2001:0db8:0020:0003:1000:0100:0020:0003 -count 3
Success
The following example displays the command execution result when the multiple IP address setting is
enabled and virtual port information number #1 of the port for which the virtual port information is enabled
is specified:
CLI> test iscsi-ping -port 100 -ip 192.168.2.10 -additional-ip 1
Success
368
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED P2X0-1210-05ENZ0