Set Network - Fujitsu Eternus DX100 S3 User Manual

Chapter 5 System Settings and Display
5.2 Network Management > set network

set network

This command sets up parameters for the Ethernet network, and checks the consistency of parameters. If the
system detects an inconsistency between the parameters, the command is terminated abnormally.
• This command releases the factory default network setting when the factory default network setting is
used. Before releasing the factory default network setting, set the MNT port.
When a port other than the MNT port is set while the factory default network setting is used, a connection
to the MNT port becomes impossible and a warning message appears. Make sure to set the MNT port first
when the factory default network setting is used.
• An IP address can be deleted by specifying it as "0.0.0.0".
• An IP address that is used for connection to the MNT port on the master controller module (CM) cannot be
deleted.
• When critical changes are made (such as changing a subnet address), all of the network parameters
should be reconfigured.
• When the command is executed, the CLI session is logged off automatically.
• When "fst" is specified for "-port", gateway, DNSs and IP addresses cannot be set.
■ Syntax
set network -port {maintenance | remote | fst} [-ip-format {v4|v6}] [-ipv6-set-auto {disable|enable}]
[-master-ip
[-slave -link-local-ip
netmask
[-netmask
[-allow-ip1
[-allow-ip4
[-allow-ip7
[-allow-ip10
[-allow-ip13
[-allow-ip16
[-primary-dns-ip
■ Parameter
-port
ip_address ip_address
] [-slave-ip
ip_address
] [-master-connect-ip
] [-subnet-prefix-length
ip_address netmask
, ] [-allow-ip2
ip_address netmask
, ] [-allow-ip5
ip_address , netmask ] [-allow-ip8
ip_address netmask
, ] [-allow-ip11
ip_address netmask
, ] [-allow-ip14
ip_address netmask
, ] [-speed {1000|100full|100half|10full|10half|auto}]
ip_address
] [-secondary-dns-ip
This parameter specifies the Ethernet port.
maintenance
Maintenance port (MNT port)
remote Remote port (RMT port)
fst FST port
"fst" is not supported in the ETERNUS DX100 S3/DX200 S3 and the ETERNUS DX200F.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
ip_address
] [-master-link-local-ip
ip_address
] [-slave-connect-ip
length gateway
] [-gateway
ip_address netmask
, ] [-allow-ip3
ip_address netmask
, ] [-allow-ip6
ip_address , netmask ] [-allow-ip9
ip_address netmask
, ] [-allow-ip12
ip_address netmask
, ] [-allow-ip15
ip_address
] [-wake-on-lan {enable|disable}]
495
]
ip_address
]
]
ip_address netmask
, ]
ip_address netmask
, ]
ip_address , netmask ]
ip_address netmask
,
ip_address netmask
,
P2X0-1210-05ENZ0
]
]