Fujitsu Eternus DX100 S3 User Manual page 76

Chapter 3 Configuration Settings and Display
3.1 RAID Group Management > create raid-group
-stripe-depth
-fr-consist
■ Example(s)
The following example creates a RAID group named "RGP001". RAID1 level is assigned using disks #003 and
#004:
CLI> create raid-group -name RGP001 -level 1 -disks 003,004
Optional. This parameter specifies the stripe depth for the RAID group that is to be created. If
omitted, then it is handled as if "64kb" is selected. The available values vary depending on the
RAID level and the number of drives.
64kb 64KB
128kb 128KB (Only for RAID 5 configurations of 10 or more disks, RAID 0 configurations,
and RAID1+0 configurations)
256kb 256KB (Only for RAID 5 configurations of 9 or less disks, RAID 0 configurations,
and RAID1+0 configurations)
512kb 512KB (Only for RAID 5 configurations of 5 or less disks, RAID 0 configurations,
and RAID1+0 configurations)
1024kb 1024KB (Only for RAID0 configurations and RAID1+0 configurations)
Optional. This parameter specifies the disks that consist of the Fast Recovery RAID group. In
the case of RAID6-FR configurations, this parameter must be specified.
(3D+2P)x2+1HS
RAID6(3+2)×2, HS×1
(6D+2P)x2+1HS
RAID6(6+2)×2, HS×1
(9D+2P)x2+1HS
RAID6(9+2)×2, HS×1
(12D+2P)x2+1HS
RAID6(12+2)×2, HS×1
(5D+2P)x4+1HS
RAID6(5+2)×4, HS×1
(13D+2P)x2+1HS
RAID6(13+2)×2, HS×1
(3D+2P)x6+1HS
RAID6(3+2)×6, HS×1
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
76
P2X0-1210-05ENZ0