Show Firewall - Fujitsu Eternus DX100 S3 User Manual

Chapter 5 System Settings and Display
5.2 Network Management > show firewall

show firewall

This command displays the status of each Ethernet application service port.
■
Syntax
show firewall
■ Parameter
No parameters.
■ Output
MNT Port
RMT Port
FST Port
http
https
telnet
SSH
Maintenance-Secure
ICMP
SNMP
RCIL
ETERNUS DX Discovery
Maintenance port (MNT port) name
Remote port (RMT port) name
Field support port (FST port) name
(This information is not supported in ETERNUS DX100 S3/DX200 S3 and the ETERNUS DX 200F.)
Indicates whether an http connection is enabled. (open: enabled, close: disabled)
Indicates whether an https connection is enabled. (open: enabled, close: disabled)
Indicates whether a telnet connection is enabled. (open: enabled, close: disabled)
Indicates whether an SSH connection is enabled. (open: enabled, close: disabled)
Indicates whether an ETERNUS Maintenance Secure connection is enabled. (open: enabled,
close: disabled)
Indicates whether an ICMP connection is enabled. (open: enabled, close: disabled)
Indicates whether an SNMP connection is enabled. (open: enabled, close: disabled)
Indicates whether an RCIL connection is enabled. (open: enabled, close: disabled) (MNT port
only)
Indicates whether ETERNUS DX Discovery is enabled. (open: enabled, close: disabled) (MNT
port only)
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
502
P2X0-1210-05ENZ0