Chapter 7 NAS Function Setting and Display
7.5 Network Settings > show nas-port
show nas-port
This command displays information of the parameters that are used to control NAS ports.
■
Syntax
show nas-port [-port
■
Parameter
-port
■
Output
Location
MAC Address
Transfer Rate
MTU
CIFS
NFS
RIP
ICMP
Link detected
Speed
Duplex
ports
]
Optional. This parameter specifies the NAS port of which information is to be displayed based
on the format of the host interface. Multiple member ports can be specified by inserting a
comma (,) between them as a delimiter.
If a non-NAS port is specified, the target port information is not displayed.
ports
NAS port
Example: -port 000,001
NAS port number of which information is to be displayed
MAC address
The transfer rate and the communication method (bandwidth) setting of the NAS port
MTU size setting
CIFS connection firewall setting
NFS connection firewall setting
RIP connection firewall setting
ICMP connection firewall setting
Current link status
Transfer rate of the current link
Communication method (bandwidth) of the current link
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
771
P2X0-1210-05ENZ0