Fujitsu Eternus DX100 S3 User Manual page 876

Appendix A Error Messages/Error Codes
A.1 Error Messages
Message
number
ED2CE
ED50A
ED50B
ED50C
ED50D
ED50E
ED50F
ED511
ED513
ED514
ED517
ED518
ED519
ED51A
ED51B
ED51C
ED51D
ED51E
ED523
ED524
Volume Type which is the Migration destination is different.
The volume type of the migration destination differs from the volume type of the migration source.
The number of drives that is used exceeds the maximum number.
The number of drives that is used exceeds the maximum number.
The target mapping table number exceeds the maximum number in the allowed range.
The target mapping table number exceeds the allowed range.
The target OLU already exists in the same mapping table.
The target OLU already exists in the same mapping table.
Incorrect parameter combination.
Some of the specified parameters are incorrect.
The specified host number exceeds the maximum number in the allowed range.
The specified host number exceeds the maximum number in the allowed range.
The WWN that is to be registered is duplicated.
The WWN that is to be registered is duplicated.
CA port is overlapping in group.
The settings are duplicated for a single CA port of a single host.
The specified LCU number exceeds the maximum number in the allowed range.
The specified LCU number exceeds the maximum number in the allowed range.
The specified host response number exceeds the maximum number in the allowed range.
The specified host response number exceeds the maximum number in the allowed range.
A copy session is running.
A copy session is running.
The connected device does not support this function.
The ETERNUS DX that is connected is not supported.
The forwarding interval cannot be specified when the ETERNUS6000 is connected.
The forwarding interval cannot be specified when the ETERNUS6000 is connected.
The buffer size exceeds the maximum size for the device.
The buffer size exceeds the maximum size for the ETERNUS DX.
REC Buffer has already been configured. The process was aborted.
The REC buffer setting has already been applied.
The storage is in "Not Ready" state. The process was aborted.
The ETERNUS DX is in Not Ready status.
The REC disk buffer contains some data.
The REC disk buffer contains some data.
Some REC Consistency sessions are not in Suspend status.
Some REC Consistency sessions are not in Suspend status.
The number of migration sessions has reached the maximum number for operations in the device.
The number of migration sessions has reached the maximum number for operations in an ETERNUS DX.
The migration source LUN is being used by another migration process.
The migration source LUN is being used by another migration process. Wait for a while and try again.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
Message
Countermeasure for the error
876
P2X0-1210-05ENZ0