Fujitsu Eternus DX100 S3 User Manual page 844

Appendix A Error Messages/Error Codes
A.1 Error Messages
Message
number
E5339
E5340
E5341
E5342
E5343
E5344
E5345
E5346
E5347
E5348
E5349
E5350
E5351
E5352
E5353
E5354
It will lead to copy destination volumes overlap. EC/REC cascade copy session cannot be reversed.
The copy destinations of some sessions overlap each other because the EC/REC session that is cascaded is
reversed.
SDV is being initialized.
An SDV is being initialized.
There is already a copy session where the specified SDV was set as copy destination.
A session for which the copy destination is an SDV exists.
The copy session has already been set.
The copy session has already been set.
The copy session has already been deleted.
The copy session has already been deleted.
The copy session is in progress of transition to "Suspend" state asynchronously or has already been in
"Suspend" state.
The session to which the SUSPEND command is issued is being asynchronously transitioned to Suspend
status.
The session has been transitioned to Suspend status.
The state of the session is already Active.
The session is already in Active status.
The copy table has not been set yet.
The copy table has not been set yet.
Copy table size is not sufficient.
The size of the copy bitmap is not sufficient.
REC buffer is not in "Active" state.
The REC buffer is not in Active status.
Copy source and copy destination, usage (sending or receiving) of REC buffer settings after resuming copy
sessions don't match the original settings.
The copy source and the copy destination do not correspond with the sender and receiver targets of the
REC buffer after the copy session is reversed.
REC buffer setting is being changed or REC buffer related functions are in progress.
The REC buffer setting is being changed. An REC buffer operation is running with ETERNUS Web GUI or
ETERNUS CLI.
Copy source and copy destination, usage (sending or receiving) of REC buffer settings after reversing copy
sessions don't match the original settings.
The REC buffer setting is being changed. An REC buffer operation is running with ETERNUS Web GUI or
ETERNUS CLI.
The disk configured the RAID group of the specified volume is in motor OFF state due to ECO-mode.
The specified LU cannot be copied because the drive motor is turned off (this applies for OPC sessions).
The specified BoxID cannot be found.
The specified Box ID information cannot be found in the configuration information.
The copy path is not in "Normal" state. Copy sessions in this storage were deleted but copy sessions in the
remote storage still exist.
The session could be deleted in the local ETERNUS DX but could not be deleted in the remote ETERNUS DX
because of an error in the path status.
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
Message
Countermeasure for the error
844
P2X0-1210-05ENZ0