Fujitsu Eternus DX100 S3 User Manual page 245

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set iscsi-parameters
-header-digest
-data-digest
-jumbo-frame
-rate
Optional. This parameter specifies whether or not the PDU header's CRC32C checksum is
validated. The initial value is set to disabled. Specify "disable" for the "-header-digest"
parameter to disable the Digest function. When "enable" is specified for the "-header-digest"
parameter, data transfer may fail. If omitted, the existing setting is not changed. This
parameter cannot be specified when the port is set to the RA mode.
enable PDU header is validated by CRC32C.
disable PDU header is not validated.
Optional. This parameter specifies whether or not the PDU data's CRC32C checksum is
validated. The initial value is set to disabled. Specify "disable" for the "-data-digest" parameter
to disable the Digest function. When "enable" is specified for the "-data-digest" parameter,
data transfer may fail. If omitted, the existing setting is not changed. This parameter cannot
be specified when the port is set to the RA mode.
enable PDU data is validated by CRC32C.
disable PDU data is not validated.
Optional. This parameter specifies whether or not jumbo frame can be specified. If omitted,
the existing setting is not changed. The initial value is set to disabled.
This parameter can be specified as a parameter for the multiple IP address setting.
This parameter cannot be specified when the port is in RA mode or CA/RA auto mode.
enable The jumbo frame is accepted.
disable The jumbo frame is not accepted.
To transfer data via Jumbo Frame, make sure the device that is to be connected to the iSCSI
network supports Jumbo Frame.
Optional. This parameter specifies the connection speed of the iSCSI port.
If omitted, the existing setting is not changed. The default value is 10Gbit/s for 10Gbit/s iSCSI,
and 1Gbit/s for 1Gbit/s iSCSI and iSCSI-RA (for connecting older models).
1gauto 1Gbit/s Auto
For 1Gbit/s iSCSI CA/RA auto mode
10gauto 10Gbit/s Auto
For 10Gbit/s iSCSI CA/RA auto mode
1gfull 1Gbit/s Full Duplex
For iSCSI-RA (for connecting older models)
100mfull 100Mbit/s Full Duplex
For iSCSI-RA (for connecting older models)
auto Auto negotiation
For iSCSI-RA (for connecting older models)
ETERNUS CLI User's Guide
Copyright 2014 FUJITSU LIMITED
245
P2X0-1210-05ENZ0