CHAIN DRIVE/DRIVE SYSTEM
16. Torque the 4 nuts to 75 ft-lbs. (102 Nm) (Fig. 0306).
17. Apply general purpose oil (10W30) to the upper and
lower chain spans.
18. Start the traction unit and slowly move it forward to
expose the upper and lower chain spans that have
not been lubricated.
19. Stop the engine and remove the key.
20. Apply oil to newly exposed non-lubricated chain
spans.
21. Lower the machine to the ground.
4/1-10
DSC-0588a
Fig. 0306
Front Axle Replacement
Front Axle Removal
1. Park CUL on a level surface
2. Raise the loader arm 6" - 12" (15 - 30cn) off the
ground.
3. Turn off the machine and remove the key.
4. Lift the rear of the machine (Fig. 0307).
5. Position jackstands under the rear 2 corners of the
machine. Remove the floor jack (Fig. 0308).
Toro Wheeled CUL Service Manual
DSC-0100a
Fig. 0307
DSC-0099a
Fig. 0308