Rear Wheel Motor Replacement
Rear Wheel Motor Removal
1. Park CUL on a level surface.
2. Raise the loader arm 6" - 12" (15 - 30cm) off the
ground.
3. Turn off the machine and remove the key.
4. Lift the rear of the machine (Fig. 0926).
5. Position jackstands under the rear 2 corners of the
machine. Remove the floor jack (Fig. 0927).
Toro Wheeled CUL Service Manual
4-PAW GAS/DRIVE SYSTEM
DSC-0100a
Fig. 0926
DSC-0099a
Fig. 0927
6. Raise the front of the machine (Fig. 0928).
7. Position jackstands under the front 2 corners of the
machine. Remove the floor jack (Fig. 0929).
DSC-3924a
Fig. 0928
DSC-3925a
Fig. 0929
5/1-13