Toro 22317 Service Manual page 54

7. Flush the valve body with a solvent and then com-
pressed air to clean it out. Inspect the manifold and
flow divider for any scratches or wear.
8. Install the o-rings and back-up rings onto the spool
(Fig. 0112).
9. Lubricate the o-rings and seals. Push the flow diver
valve into the valve body (Fig. 0113).
Toro Wheeled CUL Service Manual
IMG-0529a
Fig. 0112
IMG-0530a
Fig. 0113
ALL UNITS/GENERAL
10. Install an o-ring and a snap ring on each side of the
flow divider (Fig. 0114).
11. Install a new o-ring on each plug. Install a plug into
the side opposite the spool (Fig. 0115).
IMG-0531a
Fig. 0114
IMG-0533a
Fig. 0115
3/1-31