4-PAW DIESEL/HYDRAULICS
23. Slide the air cleaner hose onto the engine intake.
Position the hose clamp and tighten to secure (Fig.
1367).
24. Start the machine. Allow the air to purge from the
hydraulic system. Check the hydraulic lines and
fittings for leaks.
25. Turn the machine off and remove the key.
26. Add hydraulic fluid if necessary.
27. Close the engine rear cover and latch.
6/2-14
Fig. 1367
DSC-3050a
Hydraulic Auxiliary, Selector & Flow
Divider Valves
Hydraulic Auxiliary, Selector & Flow Divider
Valves Removal
Note: Upon removal, all seals, o-rings and gaskets
should be replace. During installation, lightly
lubricate all seals, o-rings and gaskets with
clean petroleum jelly prior to assembly.
1. Mark the hydraulic line and fitting on the flow divider
valve (A) (Fig. 1368).
Toro Wheeled CUL Service Manual
Fig. 1368
DSC-2961a