12. Position the pump mount/idler assembly to the
engine block. Route the belt around the drive pulley.
Loosely install the 4 bolts and lock washers securing
the pump mount/idler assembly to the engine block
(Fig. 1923).
Note: The bottom 2 mounting bolts are located
below the pump mount opening and bolt
the bottom of the pump mount to the engine
block. Using a 1/2" socket, tighten the 4 pump
mount assembly mounting bolts.
Toro Wheeled CUL Service Manual
Fig. 1923
DSC-1745a
4-PAW DIESEL/ENGINE
13. Turn the engine until the 2 pump coupler set screws
are positioned at approximately 1 o'clock and 3
o'clock (Fig. 1924).
14. Ensure the key is installed in the pump shaft keyway
(Fig. 1925).
Fig. 1924
DSC-1747a
Fig. 1925
DSC-1749a
6/4-87