21. Install a new shaft seal in the pump cover so that the
spring side of the seal is facing the housing side of
the pump cover (Fig. 0197).
22. Carefully drive the seal into the cover until it is
seated (Fig. 0198).
Toro Wheeled CUL Service Manual
IMG-0238a
Fig. 0197
IMG-0239a
Fig. 0198
ALL UNITS/GENERAL
23. Install the snap ring into the pump cover (Fig. 0199).
24. Remove the bushing from the drive gear and driven
gear shafts (Fig. 0200).
IMG-0240a
Fig. 0199
IMG-0241a
Fig. 0200
3/1-55