Toro 22317 Service Manual page 437

4-PAW DIESEL/HYDRAULICS
14. Slide the counterbalance valve assembly out the
rear of the chassis so that the 2 hydraulic lines that
are still attached can be accessed and removed
(Fig. 1486).
15. Support the counterbalance valve by placing a
1-1/16" wrench on the front, lower counterbalance
valve fitting. Use a 1-1/8" wrench to remove the rear
wheel motor hydraulic line nut from the counter-
balance valve fitting (Fig. 1487).
6/2-46
Fig. 1486 DSC-1914a
Fig. 1487 DSC-1916a
16. Support the counterbalance valve using a 1-1/16"
wrench on the 90 degree fitting located on the
bottom of the counterbalance valve. Use a 1-1/8"
wrench to remove the hydraulic line nut from the
counterbalance valve fitting (Fig. 1488).
17. Remove the counterbalance valve from the chassis
(Fig. 1489).
Toro Wheeled CUL Service Manual
Fig. 1488 DSC-1919a
Fig. 1489 DSC-1922a