22. Inspect the rubber boot for cracks and damage; re-
place as neede. Apply grease to the ball on all 4 of
the operator assemblies (Fig. 0035).
23. Install a gasket onto each of the 4 operator assemb-
lies. Install each operator assembly onto the 4-spool
valve body (Fig. 0036).
Toro Wheeled CUL Service Manual
IMG-0480a
Fig. 0035
IMG-0482a
Fig. 0036
ALL UNITS/GENERAL
24. Install the 2 detents for the neutral safety switches
(Fig. 0037).
25. Install new o-rings onto the two switch block mounts.
Install the 2 switch block mounts onto the 2 center
spools (Fig. 0038).
IMG-0483a
Fig. 0037
IMG-0485a
Fig. 0038
3/1-11