Toro 22317 Service Manual page 305

4-PAW GAS/HYDRAULICS
6. Lower the loader arm until the loader arm end of the
cylinder rods are resting on the cylinder locks.
7. Loosen the 4 swell latches securing the hood to the
main frame (Fig. 1013).
8. Remove the hood (Fig. 1014).
5/2-12
Fig. 1013 DSC-0982a
Fig. 1014 DSC-0983a
9. Lift the rear of the machine (Fig. 1015).
10. Position jackstands under the rear 2 corners of the
machine. Remove the floor jack (Fig. 1016).
Toro Wheeled CUL Service Manual
Fig. 1015 DSC-0100a
Fig. 1016 DSC-0099a