10. Remove the support from the loader arm.
11. Position the female flush face coupler into the out-
side hole of the coupler bracket on the loader arm
(Fig. 1576).
12. Using a 1-5/16" wrench install the nut to the female
flush face coupler (Fig. 1577).
Toro Wheeled CUL Service Manual
4-PAW DIESEL/LOADER ARM
Fig. 1576
DSC-1468a
DSC-1470a
Fig. 1577
Note: Upon removal, all seals, o-rings and gaskets
should be replaced. During installation, lightly
lubricate all seals, o-rings and gaskets with
clean petroleum jelly prior to assembly.
13. Position the male flush face coupler into the coupler
bracket on the loader arm (Fig. 1578).
14. Using a 1-1/4" wrench and 1-5/16" wrench install the
nut to the male flush face coupler (Fig. 1579).
DSC-1471a
Fig. 1578
DSC-1474a
Fig. 1579
6/3-9