Toro 22317 Service Manual page 64

4. Install a spanner wrench in the holes located on
the head. Rotate the head counter-clockwise until
the beveled edge of the retaining ring appears in
the milled locking slot of the barrel. Insert a flat
blade screwdriver between the beveled edge of the
retaining ring and the milled locking slot (Fig. 0145).
5. Continue to rotate the head counter-clockwise until
the retaining ring is completely removed (Fig. 0146).
Toro Wheeled CUL Service Manual
IMG-0322a
Fig. 0145
IMG-0323a
Fig. 0146
ALL UNITS/GENERAL
6. Pull the cylinder rod assembly out of barrel (Fig.
0147).
7. Remove the barrel from the vise.
Hydraulic Cylinder Assembly (Fig. 0148):
C D
A. Barrel
B. Retaining ring
C. Piston
IMG-0325a
Fig. 0147
A
E
IMG-0327a
Fig. 0148
D. Head
E. Cylinder rod
B
3/1-41