Toro 22317 Service Manual page 327

4-PAW GAS/LOADER ARM
23. Using a 1/2" socket, install 3 bolts securing each
of the pivot pins to the attach plate (2) and the tilt
cylinder ram (1) (Fig. 1098).
24. Torque the 3 pivot pin bolts to 19 ft-lbs. (26 Nm)
(Fig. 1099).
5/3-12
DSC-1493a
Fig. 1098
DSC-1494a
Fig. 1099
25. Remove the floor jack.
26. 4-Paw machines: Install the hood.
27. Start the machine. Raise and lower the loader arm.
28. Check the hydraulic fluid level and add if necessary.
29. Grease the pivot points (using #2 general purpose
luthium grease):
Left side (Fig. 1100)
Toro Wheeled CUL Service Manual
DSC-1497a
Fig. 1100