9. Remove the upper pivot pin (Fig. 1064).
Note: Support the cylinder with one hand as you
remove the upper pivot pin.
10. Lay the tilt cylinder alongside the unit (Fig. 1065).
Toro Wheeled CUL Service Manual
DSC-1401w
Fig. 1064
DSC-1402w
Fig. 1065
4-PAW GAS/LOADER ARM
11. Mark the hydraulic lines to the flush face couplers
with an M for male and F for female relating to the
couplers (Fig. 1066).
12. Place an oil pan underneath the couplers to catch
drainage.
13. Using a 1-1/8" wrench remove the hydraulic line to
the male (M) flush face coupler (Fig. 1067).
Note: Use a plug to protect the line from contami-
nation.
DSC-1403a
Fig. 1066
DSC-1405a
Fig. 1067
5/3-3