Lift Cylinder Installation - Toro 22317 Service Manual

CHAIN DRIVE/HYDRAULICS
11. Remove the two 90º fittings from the lift cylinder (Fig.
0674 and Fig. 0675).
12. To service the lift cylinder, refer to "100-4163
Hydraulic Cylinder Rebuild" (Old Style) for 2004 and
older units, on page 3/1-17 or "105-7867 Hydraulic
Cylinder Rebuild" (New Style) for 2005 and newer
units, on page 3/1-40.
4/2-38
Fig. 0674 DSC-2914a
Fig. 0675 DSC-2915a

Lift Cylinder Installation

1. Install the 2 hydraulic fittings in the lift cylinder.
Position the fittings so they are facing each other
(Fig. 0676).
Note: The marked fitting goes into the port on the
ram end of the cylinder barrel.
2. Position the lift cylinder in the machine with the ram
end facing up (Fig. 0677).
Toro Wheeled CUL Service Manual
Fig. 0676 DSC-2916a
Fig. 0677 DSC-2920a