4-PAW GAS/DRIVE SYSTEM
Rear Wheel Motor Installation
Note: Upon removal, all seals, o-rings and gaskets
should be replaced. During installation, lightly
lubricate all seals, o-rings and gaskets with
clean petroleum jelly prior to assembly.
1. Place the wheel motor onto a floor jack with the
fittings facing to the side. Position the wheel motor
under the main frame (Fig. 0953).
2. Raise the floor jack and position the wheel motor
into the opening in the main frame so the mounting
holes in the wheel motor align with the mounting
holes in the mainframe (Fig. 0954).
5/1-20
DSC-0869a
Fig. 0953
DSC-0872
Fig. 0954
3. Loosely install 4 wheel motor mounting bolts (Fig.
0955).
4. Using a 3/4" socket, tighten and torque the 4 mount-
ing bolts to 75 ± 8 ft-lbs. (102 ± 11 Nm) (Fig. 0956).
Toro Wheeled CUL Service Manual
DSC-0873
Fig. 0955
DSC-0874
Fig. 0956