Pump Mount Assembly Rebuild
1. Remove the bolt, flat washer, idler pulley, spacer,
and nut securing the tensioner arm to the pump
mount assembly (Fig. 1982).
2. Remove the locknut, 2 spacers, and carriage bolt
securing the top of the tensioner arm to the pump
mount assembly (Fig. 1983).
Toro Wheeled CUL Service Manual
Fig. 1982
IMG-0631a
Fig. 1983
IMG-0633a
4-PAW DIESEL/ENGINE
3. Remove locknut, 2 washers, spacer, and bolt secur-
ing the bottom of the tensioner arm to the pump
mount assembly (Fig. 1984).
4. Loosen the two square head set screws securing the
pulley to the pump mount fan shaft (Fig. 1985).
Fig. 1984
IMG-0634a
Fig. 1985
IMG-0637a
6/4-103