Battery Installation - Toro 22317 Service Manual

6. Lower the loader arm down until the loader arm end
of the cylinder rods are resting on the cylinder locks.
7. Disconnect the negative and then the positive
battery cable. Remove the wing nut, washer and
carriage bolt securing the battery clamp to the frame.
Remove the battery clamp (Fig. 0871).
D
A. Negative battery cable C. Wing nut, washer,
B. Positive battery cable
8. Remove the battery from the frame (Fig. 0872).
Toro Wheeled CUL Service Manual
CHAIN DRIVE/ELECTRICAL
C
A
B
Fig. 0871 DSC-0447a
carriage bolt
D. Battery clamp
Fig. 0872 DSC-0458a

Battery Installation

1. Position the battery into the frame (Fig. 0873).
2. Position the battery clamp onto the battery, up
against the frame. Install a carriage bolt washer and
wing nut to secure the battery clamp to the frame.
Connect the positive and then the negative battery
cable (Fig. 0874).
D
A. Negative battery cable C. Carriage bolt, washer,
B. Positive battery cable
Fig. 0873 DSC-0458a
C
A
B
Fig. 0874 DSC-0447a
wing nut
D. Battery clamp
4/5-7