4-PAW GAS/HYDRAULICS
12. Start the machine. Allow the air to purge from the
hydraulic system. Check the hydraulic lines and
fittings for leaks. Remove the drain pan.
13. Turn the machine off and remove the key.
14. Slide the rear wheel onto the wheel hub (Fig. 1007).
15. Loosely install 5 lug nuts (tapered side in) (Fig.
1008).
5/2-10
Fig. 1007
DSC-0976a
Fig. 1008
DSC-0977a
16. Torque all 5 lug nuts to 50 + 5 ft-lbs. (68 + 7 Nm)
(Fig. 1009).
17. Check the hydraulic fluid level and add fluid if
necessary.
18. Remove the unit from the jackstands.
19. Raise the loader arms; remove and re-stow the
loader arm cylinder locks.
20. Test operate the machine.
Toro Wheeled CUL Service Manual
Fig. 1009
DSC-0978a