4-PAW GAS/LOADER ARM
15. Using a 1-1/8" wrench install the hydraulic line (F) to
the female flush face coupler (Fig. 1090).
16. Using a 1-1/8" wrench install the hydraulic line (M) to
the male flush face coupler (Fig. 1091).
5/3-10
DSC-1479a
Fig. 1090
Fig. 1091
DSC-1481a
17. With the fittings facing up toward the engine, position
the tilt cylinder in the center of the loader arm (Fig.
1092).
18. Install the upper pivot pin through the tilt cylinder
yoke and loader arm bracket (Fig. 1093).
Toro Wheeled CUL Service Manual
Fig. 1092
DSC-1482a
Fig. 1093
DSC-1483a