62. Check and adjust the alternator belt tension. Refer
to "Checking the Alternator Belt Tension" on page
6/4-60.
63. Place suitable lumber on the operator's platform.
Raise the engine and place it on the lumber (Fig.
1758).
64. Remove the hoist chains and hoist.
65. Slide the engine into the frame aligning the mounting
holes on the engine mount with the holes in the
frame (Fig. 1759).
Toro Wheeled CUL Service Manual
Fig. 1758
DSC-2596a
Fig. 1759
DSC-2600a
4-PAW DIESEL/ENGINE
66. Remove the lumber from the operators platform.
67. Using a 1/2" socket, Install 4 new special cap screws
and washers to secure the engine mount to the
frame (Fig. 1760).
Note: The cap screws have a drilock adhesive
on the threads and must be replaced upon
removal.
68. Using a 1/2" socket, torque the 4 cap screws to 35 to
45 ft-lbs. (47 to 61 Nm) (Fig. 1761).
Fig. 1760
DSC-2602a
Fig. 1761
DSC-2604a
6/4-43