Industrial Robot: SCARA Robots GX series Manual
✏
POINTS
The brake release switch is used with both Joint #3 and Joint #4. Press the brake release switch while in the
emergency stop state to simultaneously release the brakes on Joint #3 and Joint #4.
When pressing the brake release switch, watch for the shaft descending or rotating under the weight of the hand.
2.1.7 ACCELS Setting for CP Motion
To make the Manipulator move in a CP motion, make the appropriate ACCELS settings in the SPEL program based on the tip
load and Z-axis height.
✏
POINTS
If the ACCELS settings are not properly configured, the following problem may occur.
Shortened lifespan and damage to the ball screw spline
Set ACCELS as shown below based on the Z-axis height.
ACCELS setting values by the Z-axis height and tip load
Z-axis Height (mm)
3 kg or Less
- 0 > Z ≥ - 50
- 50 > Z ≥ - 100
25000 or less
- 100 > Z ≥ - 150
a
Z
Symbol
Description
a
Z-axis height 0 (origin position)
Tip Load
4 kg or Less
25000 or less
25000 or less
21500 or less
Rev.7
22