Wall Mounting Specifications - Epson GX Series Manual

Industrial Robot: SCARA Robots GX series Manual
✏
POINTS
If the cable is routed by exiting from the bottom side:
Make sure there is enough space in the center of the base table where the base will be secured in place.
Diameter: ø150 mm or more
Depth: M/C cable L-angle type 120 mm or more, M/C cable straight type 190 mm or more

3.3.4.3 Wall Mounting Specifications

WARNING
Be sure to always use two or more people when installing or relocating the model with wall mounting
specifications. The Manipulator weights are as follows. Be careful not to get hands or feet caught or have
equipment damaged due to dropping of the Manipulator.
GX8-A45**W, GX8-B45**W: Approx.35 kg (77 lbs)
GX8-A55**W, GX8-B55**W: Approx.36 kg (79 lbs)
GX8-A65**W, GX8-B65**W: Approx.37 kg (82 lbs)
When installing the Manipulator on a wall or similar structure, support the Manipulator until all of the anchor
bolts are secured in place. Removing the support before the anchor bolts are fully secured is extremely
hazardous and may cause the Manipulator to fall.
Standard specifications
Rev.7
191