Multiple Mounting Specifications - Epson GX Series Manual

Industrial Robot: SCARA Robots GX series Manual
Symbol Description
a 4 × M8 × 30
b Spring washer
c Plain washer
4 × M8 threaded hole
d
(20 mm or more depth)
e 10 mm
✏
POINTS
If the cable is routed by exiting from the bottom side, make sure there is enough space in the center of the base
table where the base will be secured in place.
Height: 190 mm min.
Width: 104 mm
Depth: 190 mm or more

2.3.4.3 Multiple Mounting Specifications

WARNING
Be sure to always use two or more people when installing or relocating the model with multiple mounting
specifications. The Manipulator weights are as follows. Be careful not to get hands or feet caught or have
equipment damaged due to dropping of the Manipulator.
GX4-A301*M, GX4-B301*M: Approx. 17 kg (38 lbs)
GX4-A351*M, GX4-B351*M: Approx. 17 kg (38 lbs)
When installing the Manipulator on a wall or similar structure, support the Manipulator until all of the anchor
bolts are secured in place. Removing the support before the anchor bolts are fully secured is extremely
hazardous and may cause the Manipulator to fall.
Rev.7
66